Portable data recorder DR-7100
FAQ
- (If the clock display is not working) Regarding the initialization of the internal clock
- How to display sound data from a sound level meter or microphone as sound pressure level using Auscope Basic.
- The bar graph display is too large compared to the magnitude of the input signal. I set Accelerometer on the vibration calibration and input the sensor output to the DR-7100. Judging from the sensitivity value, the signal should be about 1/10 of the input voltage range, but the bar graph extends to more than half of that range. Is there something wrong with the output from the sensor?
- Please explain how to calibration the units of Accelerometer using the sensitivity data listed in the datasheet.
- How to display sound data from a sound level meter or microphone as sound pressure level using Oscope Basic (Part 2)
- How to connect a TEDS-compatible accelerometer
- Regarding triggering via signal input to external terminals (PULSE/TRIG terminals)
- I want to erase the recorded data on the SD card using the DR-7100.
- A method for recording 5 minutes at a time, repeating every hour, by specifying the start and end times - Specifying the start and end times of recording and interval recording -
- When I press the REC button to record data, it displays "0 FILES AVAILABLE" and I cannot operate it. Please tell me how to fix this.
- If a recording time exceeding 2GB is set, will recording stop at 2GB? Or will it continue recording in separate files until the SD card is full?
- During data acquisition, is a signal output from the OUTPUT (analog output terminal) (can the signal be monitored)?
- How many files are created when recording data using two DR-7100 units synchronized?
- Is it compatible with TEDS microphones?
- The file's timestamp value is incorrect.