Torque Meter Frequently Asked Questions

Settings Procedure

• Prepare an RS-232C cable to connect the TS-2600 to the computer. Make sure the LOCK switch on the front panel of the TS-2600 is set to OFF, and if the optional TS-0220 is installed, disable its internal settings.
• Only turn on the power to the computer and start Windows Me.
• Start → Programs → Accessories → Communications → Select HyperTerminal with the mouse
  
• The 'Connection Settings' window opens. It displays 'Please enter a name for the new connection and select an icon,' so enter 'TS2600,' choose an appropriate icon, and click OK.
• The content of the 'Connection Settings' window will change to input phone number information. Connection method: Select 'Direct to COM 1' and click OK. (This applies if an RS-232C cable is connected to COM 1.)
• "The properties of COM 1 will open, so we will configure the port settings."

  bit-second	9600
  data bit	8
  stop bit	1
  parity	None
  flow control	Xon/Xoff

• Click OK → The 'TS2600 Hyper Terminal' window will open.
  
• Click on File → Properties from the menu.
  
• The 'TS2600 Properties' window will open.
  
• Click on the 'Settings' tab and make the selections and configurations below.

  Check the terminal key, how to send the BackSpace key	Any setting is acceptable.
  Emulation	VT-100
  Telnet terminal ID	VT100
  Number of lines in the buffer	500
  Encoding Method	Shift JIS → OK
  ASCII settings	Add a line break character at the end of the line, Add a line break character to the received data, Check the box to wrap at the right edge → OK → OK

After performing the above operations, turn on the power of the TS-2600, and you can communicate by entering commands on the computer.

end operation

• Click in the order of File → Exit HyperTerminal.
• "Currently connected. Do you want to disconnect?" → "Yes"
  "Do you want to save session TS2600?" → "Yes"

From the next time, perform steps 1 to 3 of the setup, then select "Cancel" in the "Connection Settings" that appears after operation 4, click in the order of File → Open → select "TS2600" from the list of files → Open, and then turn on the power of the TS-2600 to enable communication.
Also, if you place it as an icon on the desktop, it can be launched by double-clicking the icon.