Tachometer-related TM/HT/SE/GE series
FT-2500 Advanced Tachometer
FT-7200 Advanced Tachometer
HT Series Handy Tachometer
- Measurement range of HT-3200
- I'm using an HT-4200 to measure rotational speed, but the measured value is approximately twice the specified rotational speed. Could you please tell me how to resolve this?
- How can I set the full scale of the analog output to 600.0 r/min when measuring rotational speed (Lo range) (resolution 0.1 r/min) on the HT-5500?
- How can I set the full scale of the analog output to 400.0 m/min when measuring peripheral speed (resolution 0.1 m/min) on the HT-5500?
- HT-5500 Contact/Non-Contact Handheld Tachometer: "The peripheral speed ring cannot be applied, but the rotating shaft is exposed and the diameter of the rotating body is known. Can the peripheral speed be determined from the rotational speed?"
- I am using the HT-5500 contact adapter, but I cannot take measurements (Notes on using the HT-5500 contact adapter)
- I replaced the battery with a new one, but the display remains at 0.
- Is it possible to measure even if the reflective mark is cut into small pieces and used? (Applicable models: HT-4100/HT-5100/HT-5200/HT-5500, LG-9/LG-930, FG-1300, PP-940)
- Features, temperature range, and purchasing information for the reflective mark (HT-011) (Applicable models: HT-4100/HT-4200/HT-5100/HT-5200/HT-5500, LG-9/LG-930/LG-9200, FG-1200/FG-1300, PP-940)
- HT-5500 Contact/Non-Contact Handheld Tachometer: "The peripheral speed ring cannot be applied, but the rotating shaft is exposed and the diameter of the rotating body is known. Can the peripheral speed be determined from the rotational speed?"
SE/GE Series Engine Tachometer
TM-2000 series tachometer (discontinued)
TM-3100 series tachometer
- Please compare the measurement accuracy of the TM-3100 and HT-5500.
- I am using an LG-9200/TM-3130. I am measuring by attaching 25 small pieces of reflective stickers to a φ60 rotating body. I would like to know the suspected cause and solution for the following issue: I am monitoring the analog output (0-10 V) waveform from the TM on a memory recorder. While the pulse count waveform is output at regular intervals, the entire analog output waveform fluctuates up and down. (The fluctuation (up and down) varies in magnitude.)