Frequently Asked Questions about the Tachometer

In the SS interval measurement mode (a measurement mode that displays the maximum, minimum, and average values of a certain measurement interval), the analog signal is output as follows.

1. When the SS interval measurement mode is set
(Press the MENU button, and set MESURE > MESURE MODE > SS)
No analog signal will be output.

2. Press the START button to begin measurement
An analog signal corresponding to the rotational speed is output, updated every 10 ms.

3. Press the START button to end the measurement
The analog signal that was being output at the time of completion will continue to be output.

4. When the RESET button is pressed
(It will be in the state before starting the SS interval measurement mode) No analog signal will be output.