Frequently Asked Questions about the Tachometer

If you do not know the number of pulses for the combination sensor,
you can simply make the displayed values (r/min) the same with the following settings.

1. Set the MEASURE > Factor value of the TM-3100 to be the same as the Multiplier x Exponent of the TM-2100.
（Please leave the number of pulses at the initial value of 60.）

2. The FULL value of the analog output of the TM-3130 is
for example,
in the case of the TM-2130 frequency range 5 kHz, the FULL rotation speed (r/min) of the TM-3130 = 5000

3. Other information, such as the decimal point position and input coupling, can be found in the TM-2100 settings.

Note: The above applies when the display unit is r/min.