Frequently Asked Questions about Rotary Encoders

Please pay attention to the following points.

• Please wire separately from the power line that has a large electrical load connected.
• Do not run wiring parallel to or alongside power lines.
• Please keep the power cable and signal cable as far apart as possible.
• Please use signal cables with double shielding.
• Please do not extend the signal cable more than necessary.
• When supplying power to an AC power input type, be sure to wire a breaker to prevent electric shock, short circuits, and leakage.
• Please install away from devices that generate strong electric and magnetic fields.
• COM and F.G are common. Please ensure that F.G is properly grounded, as it can cause malfunctions.
• Please install in a location free from explosive atmospheres, harmful gases, and liquids.
• Please install it in a location that is not exposed to direct sunlight.
• Please install in a location free from dust, iron powder, etc.
• Please install in a place without salt.
• Please place it in a location without radioactive materials, without a magnetic field, and that is not a vacuum.
• Please install in a location where the temperature is between -5 and +55 °C and there are no rapid temperature changes.
• Please install in a location where the humidity is below 95%.
• Please install it at a location below 2000 meters in altitude.