Magneto-Electric Rotation Detector

(1) Mounting bracket
Use a non-magnetic material and secure it so that it does not move due to vibration or other factors. Tighten it with the MP-9810 / MP-9830 nut. A nut tightening force of 15-20 Nm is recommended.

(2) Alignment
Align the alignment mark (▲) on the MP-9810/MP-9830 so that it is approximately in the center of the gear tooth tip. Install the sensor so that it is perpendicular to the gear shaft. The distance from the gear should be approximately 0.5 mm for m0.5 and approximately 1 mm for m1.