CF-3600A/3800A Frequently Asked Questions

You can launch "MT7 Software → Calibration Tool" from the Start menu and align the cursor position with the point you clicked.

boot
From the Start menu, select "Programs," and then click "Calibration Tool" under "MT7 Software" in the list. After a few seconds, a target for alignment will appear in the lower left corner of the screen.

operation
Touch and release the center of the target for a few seconds, and the green mark will turn red, indicating that alignment is complete. After the bottom left is finished, the target will appear in the top right, then the top left again. Touch and release the center of each target for a few seconds in the same way. A message will be displayed when the alignment of all three points is complete.

"Accept": Clicking this will save the position. "Cancel": Cancel the changes and revert to the original state. "Test": You can check the alignment status (double-tap to exit).