CF-5200 Tracking Analysis (Discontinued Product)
FAQ
- Even when the tracking data measurement is set to a maximum rotation speed of 10,000 r/min, data is being collected at around 10,300 r/min.
- The method of averaging tracking is
- What is the relationship between FRAME-1, TRACK-1, and the input channels when switching the display of tracking measurements (refer to manual section 4.1.2 for switching display of order and frequency data)?
- CHA's OA is displayed, but how can I display TRACK-1 to TRACK-4?
- (1) I want to perform tracking analysis for 0 to 4600 rpm within 0.2 to 3 seconds, stopping after 14 rotations. (2) Should a trigger be applied?
- I am calling up memory tracking data and performing three-dimensional analysis (display). Is it possible to store this three-dimensional display data in FD?
- The speed reduction is being measured from 600 to 0 rpm, but the measurement ends when the rotational display drops below 550.
- Why does the data cut off below 78 km/h in deceleration tracking analysis?
- The Japanese language display software incorporates options for tracking analysis. The initial screen is in English.
- The torque fluctuations of the motor were analyzed through tracking at 1000 to 5000 r/min over 3 minutes. The maximum O.A value obtained from the order analysis is greater than the peak value of the O.A.
- Can EU functions be used in the display of Campbell diagrams?
- I want to store the tracking data in terms of its real (Re) and imaginary (Im) components. Is that possible? I would like to multiply it with a transfer function later.
- Can the Hilbert transform be performed while analyzing frequency counts?
- Considering the MP981 as a signal for rotating pulses, what is needed is
- Are there any easy-to-use models of rotation detectors for tracking purposes?
- How to display frequency analysis.
- The procedure for tracking measurement is
- In the tracking analysis, the DC component was cut off. (DC coupling is selected.)