CF-5200 Software Version Upgrade (Discontinued Product)
FAQ
- The current version is where to request the version upgrade.
- A calibration signal for the strain gauge (DC voltage 5V) is input using DC coupling, and the value at 0Hz on the spectrum display is 2.5V, but shouldn't it be 5V?
- In the user manual on page P5-70, it states that the average and standard deviation calculations using the time record memory can be set to an arbitrary number of data points, but it is fixed at 1024 points.
- (1) In the three-dimensional display of the power spectrum, when the interval function is turned ON, averaging cannot be performed. (2) In the auto-store of power spectrum data, if the averaging setting is ON with the interval function, it will only complete once.
- I cannot perform calculus on the time axis. I am inputting a sine wave, but it is not producing the expected waveform.
- In high-speed average mode, (1) after changing the frequency range with PAUSE, pressing START does not switch to the new range; it requires pressing PAUSE and then START again to switch. (2) Measurement data varies with different frequency ranges.
- In the vibration analysis mode menu of Easy Operation, setting the frequency to 10kHz and performing a tracking analysis results in corrupted data.
- It is easy to lock when trying to operate the 2-screen color 3D display.
- When connecting the MP series plotter (made by EPSON), the model 'MACHTET (coler L)' is not available in the selection menu.
- I want to apply a taper to the sine wave output at 50Hz, but it is not being applied.
- Stored the display of the upper screen MAG and lower screen PHASE in ASCII format for the frequency range of 105 to 355 Hz at 1 kHz. When played back in Excel, the character 'Hz' appears with all X values.
- In servo analysis, when sweeping a sine wave with an amplitude of 1V and an offset of 1V, the offset becomes zero at certain frequencies.
- Can a list of spectra be stored in ASCII format?