CF-5200 Easy Operation (Discontinued Product)
FAQ
- Can it be stored on FD in ASCII format during impact test mode?
- (1) In the impact testing mode, a message appears saying "Lower the sensitivity of CHA," but what should be done? (2) Which type of hammer tip is the best?
- What is the method to determine F/α, F/V, and F/X as described in the manual during the impact test?
- Using two accelerometers in a impact test, (1) how to determine the transfer function, α1/α0, V1/V0, X1/X0: where α = acceleration, V = velocity, X = displacement. (2) Do all these yield the same value?
- In a shock test, can a positive Y value (dB) of the transfer function be interpreted as amplification due to resonance?
- Using vibration mode. Directly connected to the NP vibration sensor. The acceleration waveform is not working well.
- What does 'AVERAGE NO.' mean in the vibration analysis mode of Easy Operation?
- In the impact test, the transfer function is being measured using an impulse hammer. Below 1.5 kHz, the coherence (COH) is high and data is being collected well, but at higher frequencies, the data becomes unsatisfactory.