Torque Common Basic FAQ (Applicable to all models)
Frequently Asked Questions (Common Items)
Accuracy and calibration
- Relationship between Factor and Zero in a Phase Difference Torque Detector (Temperature Characteristics)
- Torque detector calibration period
- About the N-0 characteristic correction function
- Digital display torque accuracy
Direction of rotation
- I want to test the rotation direction cyclically from left to right. How long does it take to switch between CW and CCW?
- Power wiring method for switching the rotation direction of the motor attached to the DD series torque sensor
- Power wiring method for switching the rotation direction of the motor attached to the DSTP series torque sensor
- I want to control the rotation direction switching of the torque sensor from an external source.
- How to check the rotation direction of the motor attached to the MD series torque sensor
- How to check the rotation direction of the motor attached to the SS series torque sensor
- The relationship between switching between CW/CCW and the ± polarity of the display/voltage output is
- How to check the rotation direction of a motor with a torque sensor
unit
- How to change the display of a TS series torque meter from kgf·m to N·m units.
- To calculate torque from motor rating:
- How to set the TS series torque meter to display in kgfm units instead of Nm units.
- N·m / kgf·m / kgf·cm / gf·cm / mN·m Torque Unit Conversion Calculation Form
- Regarding coupling selection and alignment accuracy
Installation
- Coupling and alignment work
- Wiring work and noise
- To remove the rust preventative from the torque sensor shaft
- Why is the torque sensor shaft yellow?
- Is it acceptable to mount the detector vertically? If so, what are the precautions to take during installation?
others
- Can I switch between signals from two torque sensors using a single display unit?
- Regarding matching adjustments and accuracy due to changes in signal cable length.
- Are the input and output signals connected to a common ground?
- Changes to the model name and appearance of the MD series torque detector.
- Using the SENSING terminal on the MT-6113 DC power supply for test motors will trigger an alarm on the DC power supply.
- What kind of cable connects the torque sensor and the torque calculation display?
- What happens if you reverse the drive side of the torque sensor and attach it to the load side?
- TS cable bending radius
- The torque, rotational voltage output response of the TS-410 is
- Regarding external switching of the motor for MD type torque detectors
- There's a squeaking sound coming from the torque sensor unit, but is this affecting the measurement?
- Regarding external switching of the motor for SS type torque detector