Portable Data Recorder DR-7100
FAQ
- (Regarding the initialization of the internal clock when the clock display is not functioning)
- How to display sound data collected from a sound level meter and microphone as sound pressure levels using Oscilloscope Basic.
- The bar graph display is too large compared to the input signal size. The accelerometer was set to the vibration calibration device, and the sensor output was input into the DR-7100. Based on the sensitivity value, the signal should be about 1/10 of the input voltage range, but the bar graph extends beyond half. Could the output from the sensor be abnormal?
- Please tell me the method for unit calibration of the acceleration pickup using the sensitivity data listed in the data sheet.
- How to display sound data collected from the sound level meter and microphone as sound pressure level using the OS-2000 series (part 2)
- How to connect an acceleration detector compatible with TEDS.
- About triggering via signal input to the external terminal (PULSE/TRIG terminal)
- I want to operate the DR-7100 to delete the recorded data on the SD card.
- How to specify a start date and time to repeat 5-minute recordings every hour - Specifying the start and end dates and interval recordings -
- Even when I press the REC button to try to record data, it displays '0 FILES AVAILABLE' and I cannot operate it. Please tell me how to resolve this.
- When the recording time exceeds 2GB, does it stop recording at 2GB, or does it continue recording separately until the SD card runs out of space?
- Is a signal output from the OUTPUT (analog output terminal) during data recording? Is it possible to monitor the signal?
- How many files are created when synchronizing two DR-7100 devices to record data?
- Is it compatible with TEDS microphones?
- The value of the file's timestamp is incorrect.