Vibration Comparator VC Series
FAQ
- Common to VC-2200/VC-3200
- VC-2100/VC-3100 (discontinued) common
- VC-2100 (discontinued)
- VC-2200
- VC-3200
Common to VC-2200/VC-3200
- Can a signal be output externally in the case of disconnection detection?
- In Peak mode, is the displayed value for half amplitude or full amplitude?
- I want to fix the sound from the headphones to A BAND.
- I want to have the VC-3200 synchronized with the CF-4700 for analysis while the CF-4700 is analyzing.
- Does the DC output voltage value change between the PEAK and RMS measurement modes?
- About Voltage Output (THR, AC, DC)
VC-2100/VC-3100 (discontinued) common
- How should I determine the comparison setting values?
- Overview of the setup procedure
- Comparator output and terminal block (reset, gate input)
- About Voltage Output (THR, AC, DC)
- Connection of headphones
VC-2100 (discontinued)
VC-2200
VC-3200
- Does the data memory function's SAVE retain information even when the power is off? Does it start in the SAVE state when the power is turned on?
- What is the logic of alarm signal output?
- How can I save the measurement conditions set on the VC-3200 and have it start with those conditions when powered on?
- What is the cutoff frequency added by the optional filter?
- When the power is turned on, which of the five panel condition memories will be read?