CF-5200 Tracking Analysis (Discontinued Product)
FAQ
- Even when the upper limit for tracking data measurement is set to 10,000 r/min, the data is being collected at around 10,300 r/min.
- The method for averaging tracking is
- What is the relationship between FRAME-1, TRACK-1, and the input channel when switching the display for tracking measurements? (See instruction manual 4.1.2 Order and frequency data display switching)
- The OA for CHA is displayed, but how can I display TRACK-1 to TRACK-4?
- (1) I want to perform a 100-order tracking analysis with a rotation speed of 0 to 4600 rpm in 0.2 to 3 seconds, stopping after 14 rotations. What method should I use? (2) Should I use a trigger?
- The system retrieves memory tracking data for three-dimensional analysis (display). Is it possible to store this three-dimensional display data on a floppy disk?
- The deceleration measurement is performed from 600 rpm to 0 rpm, but the measurement ends when the rotation display drops below 550 rpm.
- Why does the data cut off below 78 km/h in deceleration tracking analysis?
- It includes Japanese language display software and tracking analysis options. The initial screen will be in English.
- A tracking analysis was performed on the motor's torque fluctuations of 1000 to 5000 r/min/3 minutes. The maximum OA value obtained from the order analysis was greater than the peak OA value obtained from the tracking analysis.
- Can EU functions be used when displaying the Campbell diagram?
- I want to store the Re (Real) and Im (Imaginely) data from the tracking data. Is this possible? I want to multiply it by the transfer function later.
- Is it possible to perform a Hilbert transform while performing a degree ratio analysis?
- We are considering the MP981 as the rotation pulse signal, and the necessary components are
- Are there any readily available models of rotation detectors for tracking purposes?
- How to display degree analysis
- The tracking measurement procedure is
- Tracking analysis revealed that the DC component was removed. (DC coupling was selected.)