CF-5200 Easy Operation (Discontinued Product)
FAQ
- Can data be stored on a floppy disk in ASCII format during impact test mode?
- (1) In the impact test mode, a message appears saying "Lower the CHA sensitivity". How do I do this? (2) What type of hammer tip is best?
- How can I determine F/α, F/V, and F/X as described in the instruction manual using impact testing?
- In a shock test using two Accelerometer, (1) how do you determine the transfer functions α1/α0, V1/V0, X1/X0: α = acceleration, V = velocity, X = displacement? (2) Will all of these yield the same value?
- In a shock test, if the Y value (dB) of the transfer function is positive, can it be interpreted as amplification due to resonance?
- Vibration mode is being used. The NP vibration sensor is connected directly. The acceleration waveform is not being displayed correctly.
- What does AVERAGE NO. mean in the Easy Operation vibration analysis mode?
- In impact tests, the transfer function is measured using an impulse hammer. Below 1.5 kHz, the COH (Coefficient of Handing) is high and data is obtained, but at higher frequencies, the data becomes unsatisfactory.